Manual

Page 24 of 64 General Machine Products Co., Inc.
21. Install the second seal into the
outer groove with the seal split in
the lower half of the air chamber
rotated slightly to the other side of
the vertical (compared to the first
cable seal). Ensure the groove seal
lip is away from the tractor drive
facing the sub-duct.
22. Fit the upper cable guide collet in po-
sition ensuring both seals are located
correctly.
23. Re-fit the air chamber lid ensuring cor-
rect location on the dowels and tighten
down the 4 retaining knobs.
24. The hydraulic control lever is in the
“OFF” position.
25. The speed control knob is in the “MIN”
position (fully rotated counter-clockwise).
ENSURE THAT: