Manual

Page 39 of 64 General Machine Products Co., Inc.
7. Remove the tension sprocket assembly 8. Remove the chain-connecting link.
9. Remove the chain. 10. Check the chain support slide bars for
wear. Clean and relubricate.
11. Pass the pre-lubricated new chain
around the drive sprocket. Feed the chain
along the unit and reconnect the chain-
connecting link. Remember to install the 2
center connecting link plates.
12. Align the tension sprocket with the chain
and locate into position. Insert the tension pin
through the tension sprocket. Place the ten-
sion pin spacer on the tension pin through the
opposite hole. Refit swing bolts using a 13mm
wrench. Adjust the chain evenly via the swing
bolts, checking free rotation of the chain. Do
not over tighten the chain.
Replace the chain in the top housing using the same steps that are used above for the bot-
tom housing.