Operation Manual

15•2 Reference Guide
15•2 Reference Guide
3. Select the parameter to edit.
Use the corresponding Function buttons to
select the parameters. The selected param-
eter is shown flashing.
The Reverb type shows a different set of pa-
rameters with respect to the Effects type.
4. Rotate the DIAL to modify the parameter value.
As you change value, play on the keyboard
and listen to the change.
Note: If a change of sound is not heard, the
relative DSP button is not selected (led off). Select
it (led on).
5. Check that the current effect type is selected in
the DSP section.
Press either REVERBS or EFFECTS to acti-
vate the relative DSP that you are editing.
If the current effect type if off, you will not be
able to listen to the applied changes by play-
ing on the keyboard as you edit.
6. Press ESCAPE to exit the edit of the effect type.
The display returns to the effect type selec-
tion page.
If you wish to edit the other effect type, re-
peat the procedure as described above.
1/1 EDIT:HALL1 [REVERB VOLUME/dB]
Vol=127 RvTime=1.5 InDly=100 Filter=-12
Reverb edit
3
1/1 EDIT:CHORUS1 [EFFECT VOLUME/dB]
Vol=127 FrqMod=1.5 Depth=100 Filter=-12
Effects edit
ESCAPE
ENTER
TEMPO
DATA
4
DIGITAL SIGNAL PROCESSOR
REVERBS
EFFECTS
EDIT
5
6
3. Select the parameter to edit.
Use the corresponding Function buttons to
select the parameters. The selected param-
eter is shown flashing.
The Reverb type shows a different set of pa-
rameters with respect to the Effects type.
4. Rotate the DIAL to modify the parameter value.
As you change value, play on the keyboard
and listen to the change.
Note: If a change of sound is not heard, the
relative DSP button is not selected (led off). Select
it (led on).
5. Check that the current effect type is selected in
the DSP section.
Press either REVERBS or EFFECTS to acti-
vate the relative DSP that you are editing.
If the current effect type if off, you will not be
able to listen to the applied changes by play-
ing on the keyboard as you edit.
6. Press ESCAPE to exit the edit of the effect type.
The display returns to the effect type selec-
tion page.
If you wish to edit the other effect type, re-
peat the procedure as described above.
1/1 EDIT:HALL1 [REVERB VOLUME/dB]
Vol=127 RvTime=1.5 InDly=100 Filter=-12
Reverb edit
3
1/1 EDIT:CHORUS1 [EFFECT VOLUME/dB]
Vol=127 FrqMod=1.5 Depth=100 Filter=-12
Effects edit
ESCAPE
ENTER
TEMPO
DATA
4
DIGITAL SIGNAL PROCESSOR
REVERBS
EFFECTS
EDIT
5
6
Downloaded from www.Manualslib.com manuals search engine