Install Instructions

Model DRZ™ & Model DRZ-PH™

DAMAGED ROLLER

Excessive use may wear a roller to the point of failure. It is recom-

mended that all three rollers be replaced at the same time (Cat # PO-

PH-703). The replacement roller is an assembly consisting of one

Feed Roller Bearing and two Bearing Spacers.

Note: The Bearing Spacers must be installed between the Carrier

and each Feed Roller Bearing (as illustrated below) in order to

ensure proper operation and to obtain maximum Feed Roller life.

To Replace the Feed Roller Assembly:

1. Remove the Feed Roller Assembly by unscrewing and removing

the Feed Roller Axle.

2. While holding the Feed Roller Assembly together, insert it into the

slot opening of the Carrier.

3. In order to help align the Spacers and Bearings, insert a pencil

point or similar object through the un-threaded end of the Axle

hole in the Carrier. After removing the pencil point, continue to

maintain the alignment of the components.

4. The Feed Roller Axle should then be inserted through the same

hole and should continue to be guided through the Spacers and

Bearings to the Axle hole on the other side of the Carrier.

QUICK GRIP™ CHUCK MANTENANCE

Keep chuck free of excessive soil and grit. It is recommended that the

chuck be lubricated regularly. If the chuck no longer properly grips the

cable, the grippers may have to be replaced. To do so,

1. Remove the snap ring at the end of the chuck.

2. Remove chuck knob and remove grippers.

3. Clean parts thoroughly.

4. Replace all three grippers.

5. Install chuck knob.

6. Install retaining ring.