User's Manual

WARNING: Never operate iSCAN with alkaline batteries if the Battery Type Selection
switch is set to the NI-MH position. Intentionally or accidentally recharging
non-rechargeable batteries will cause them to overheat, leak or explode. Dispose of
rechargeable batteries properly by taking them to an approved battery recycling facility.
Many communities offer battery recycling services - check with your local solid waste
management agency.
ADD RECYCLE MARK
WARNING: Always remove old or weak batteries. Batteries can leak chemicals that
destroy electronic circuits. Always turn off the scanner when not in use to prevent deep
discharge and possible battery leakage. Do not mix old and new batteries, different types
of batteries (alkaline, or rechargeable), rechargeable batteries of different capacities or
rechargeable batteries with different charge states. If you do not plan to use the scanner
with batteries for a month or longer, remove the batteries.
WARNING: Discontinue use of any battery that exhibits leakage, swelling or abnormal
generation of heat. When you charge rechargeable batteries, do not over charge them.
Overcharging shortens battery life.
Attaching the antenna
Remove the antenna from its protective plastic wrapper. Align the slots on the antenna’s
BNC male connector with the posts on iSCAN’s BNC female connector and slide the
antenna in place, then rotate the antenna’s BNC connector 1/4 turn clockwise until it snaps
in place.
NOTE: If desired, you may also connect a mobile or base station antenna equipped with a
BNC male connector to the antenna connector
Turning iSCAN on
Ensure that the Main Power Off switch on the left side of iSCAN is turned on by gently
lifting the switch’s protective cover and checking the switch position. Move the Main Power
Off switch to the ON position if necessary.