User's Manual

. Updating iSCAN’s firmware for enhancements and bug fixes
Please refer to the iSCAN PC Application’s Help system for details on using the iSCAN PC
Application.
SD Card
Your iSCAN ships with a 2 GB SD Card already formatted, installed and ready for use.
You can remove the SD Card from iSCAN and connect it to your computer, where you can
access the card with the iSCAN PC Application and update the Library, edit iSCAN’s
configuration and stored objects, optimize the card, and reformat the card if necessary. You
can also purchase additional cards, format them for use with iSCAN, then use them to
store different configurations or backups.
Inserting and removing the SD Card
NOTE: Reading from or writing to the SD card while it is installed in iSCAN is not supported.
The SD Card must be removed from iSCAN and connected to a computer using an
integrated or external SD Card interface.
To remove the SD Card from iSCAN, turn the radio off using the POWER button on the
front of the radio.
WARNING: To prevent corrupted data on the SD Card, always turn iSCAN off using the
front panel power key before removing the batteries.
Remove the door covering the battery compartment by pressing gently where the door is
marked OPEN and sliding the door downwards until it stops, approximately 1/4”. Lift the
door away from the radio. Remove the batteries to expose the SD Card slot. Push the
bottom of the SD Card upwards until a click is heard to eject the SD Card. Slide the SD
Card out of the slot to remove it from the radio.
To insert the SD Card, position the SD Card face up and slide into the slot. Press the SD
Card upwards gently until a click is heard to lock it in place. Replace the batteries and
battery compartment door.