User's Manual

Delay
Enables or disables delay for the selected object. When delay is enabled, iSCAN waits for
two seconds after a transmission to receive reply traffic before resuming scanning.
Attenuate
When checked, attenuation is enabled for the selected object. Attenuation may help reduce
interference from strong local transmitters. Use the ▶/II/SEL or  keys to toggle Attenutate
status. Attenuate is not available in the Object Menu for trunked talkgroups.
Alarm
Defines an audible alarm that is heard whenever there is activity on the object. Use the 
or  keys to select the desired alarm sound.
Light
Defines backlight behavior for the selected object. Use the  or  keys to select the
desired light behavior. Options are Leave (use default backlight settings), On (turn the
backlight on) or Flash (flash the backlight according to the Flash Pattern setting).
Flash Pattern, On Time, Off Time
Flash Pattern defines the pattern that is used for this object when the Light mode is set to
Flash. Each object uses a 32 step Flash Pattern. Each step in the 32 step flash pattern
defines whether the backlight is on or off for the durations specified in the On Time and Off
Time settings below. The 32 step Flash Pattern consists of eight blocks with four steps for
each block. The Flash Pattern within a four step block is defined using the characters 0-9
and A-F. Figure 6 illustrates the 16 individual flash patterns for each four step block.
0: ◎ ◎ ◎ ◎
1: ◎ ◎ ◎ ◉
2: ◎ ◎ ◉ ◎
3: ◎ ◎ ◉ ◉
4: ◎ ◉ ◎ ◎
5: ◎ ◉ ◎ ◉
6: ◎ ◉ ◉ ◎
7: ◎ ◉ ◉ ◉
8: ◉ ◎ ◎ ◎