User's Manual

To use Signal Stalker II, press the MENU key to access the Main Menu, then use the  key
to scroll down to the Search option. Press the  key to proceed to the Search menu. Scroll
to the Signal Stalker option and press the  key to proceed to the next menu. Select All
Bands to perform a Signal Stalker II search on all common land mobile radio bands, or
select Public Safety to perform a faster Signal Stalker II search on frequency ranges
commonly used for public safety communications. iSCAN will immediately begin to sweep
the frequency ranges you have selected. To block reception of undesired signals found
while using Signal Stalker II, press the SKIP key.
To change the Signal Stalker II options, press the MENU key while Signal Stalker II is active.
The following options are available:
Main Menu
Navigates to iSCAN’s Main Menu
Stalker Menu
Navigates to the Signal Stalker Menu
Cancel Changes
Exits the Signal Stalker Menu without saving any changes
Save Changes
Saves your changes and exits the Signal Stalker Menu
Attenuator
When checked, attenuation is enabled when using Signal Stalker II. Attenuation limits the
effective range of Signal Stalker II and may help reduce interference from strong local
transmitters. Use the ▶/II/SEL or  keys to toggle Attenuator status.
Zeromatic
Enables or disables iSCAN’s Zeromatic circuit. Zeromatic helps iSCAN tune to exact
frequencies when searching. Use the  or  keys to toggle Zeromatic enabled/disabled
status.
Delay