User's Manual

20-427 Owner’s Manual Draft
when it detects an active signal. Zeromatic functions only in Police/Fire, Aircraft,
Amateur band, and tune operation.
In the aircraft band, press FUNC then press /¥ to start searching up from the lowest
frequency or press ¥ / to start searching down from the highest frequency.
Note: If you press PAUSE while searching, the scanner stops searching and PSE appears.
Press PAUSE again, and the scanner resumes searching.
Once you find interesting frequencies during the search, you can store them into the
scanner’s channel-storage banks.
copying a frequency into a specified channel
You can copy a frequency into a specified channel when the scanner stops on that frequency
during search mode or manual tuning.
1. Press FUNC then PROG when you find a frequency. ChAnnEL appears on the display.
After about 2 second, the channel to be copied flashes.
2. Press the channel number where you want to store the frequency. The display indicates
channel number.
3. Press ENT. The scanner shows about it’s channel. (frequency or 000.0000)
4. Press ENT. All the conditions such as delay condition are copied onto the channel.
Channel number and frequency flashes two times. The scanner automatically returns to
search mode.
If you try to copy a frequency which is already stored, the scanner sounds the notice tone 3
times after you press ENT. –dUPL– appears. If you want to copy the duplicate frequency
anyway, press ENT, or if not, press CLEAR to cancel.
Page 13 of 36