User Manual

20-428 Owner’s Manual
Page 4 of 50
6. Slide the scanner into the bracket, aligning the scanner’s holes with the holes in the bracket, and
then screw the mounting knobs into the scanner.
Note: When drilling holes, be sure to avoid obstructions behind the mounting surface. Consult a
qualified installer if in doubt.
using your scanner as a base station
You can place your scanner on a desk, shelf, or table to use it as a base station. Since the speaker is
on the bottom of the scanner, you may want to use the mounting bracket to elevate your scanner off
the surface for better sound. Follow the mobile vehicle mounting instructions above to affix your
scanner to a desk, shelf, table or other flat surface (except that the bracket will be below the
scanner).
power your scanner
You can power your scanner from a wall outlet, through your vehicle’s ignition, or from your
vehicle’s cigarette lighter.
from a wall outlet
add photograph
1. Connect the tip of the supplied AC adapter to the DC 13.8V jack at the rear of your scanner.
2. Plug the AC adapter into your wall outlet.
Note: You must use a Class 2 power source that supplies 13.8V DC and delivers at least 600mA. Its
center tip must be set to positive and its plug must fit the scanner’s DC 13.8V jack. Using an
adapter that does not meet these specifications could damage the scanner or the adapter.
Warning!
To prevent electric shock, do not use the AC adapter’s polarized plug with an extension cord,
receptacle, or other outlet unless you can fully insert the blades to prevent blade exposure.
through your vehicle’s ignition
1. Disconnect the cable from the negative (–) terminal of your vehicle’s battery.
2. Ground the black wire of the supplied DC power cord to your vehicle’s chassis.
Note: Be sure the grounding screw makes complete contact with the metal frame of your vehicle.