User's Manual

20-496 Owner’s Manual Draft Page 14/78
scanner fits your vehicle’s mounting area. This scanner is a DIN-E size unit that requires a 2-inch high by 7
1/8 –inch wide by 5 5/16inch deep (50 x 180 x 135 mm) mounting area.
IN-DASH Mounting
1. Remove the sleeve from your PRO-2096.
2. Install the sleeve into the dashboard.
After the sleeve is correctly installed in the dashboard, bend the appropriate tabs to hold the sleeve firmly in
place.
3. Do the required electrical connections (power cable and antenna, etc.).
4. Slide the scanner into the sleeve until it is locked.
Removing the Unit from In-Dash Mounting
Insert the 2 handles into the slots at left and right of the front panel. Then, while gently pulling the handles
away from each other, slide out the scanner.
Mounting the Scanner with Mounting Bracket
Caution: Be sure to avoid obstructions behind the mounting surface.
1. Choose a mounting location, then use the supplied mounting bracket as a template to mark the positions
for the mounting screw holes.
2. In the marked positions, drill holes slightly smaller than the supplied screws.
3. Attach the mounting bracket to the mounting location using the supplied screws and lock washers.
4. Remove the sleeve from the unit, and attach the top and bottom cabinet to the scanner.
5. Attach a rubber washer to both of the mounting bracket’s holes.
6. Attach the scanner to the mounting bracket using the supplied mounting knobs.
7. Connect the antenna and power cable to the scanner.
POWERING THE SCANNER FROM VEHICLE’S BATTERY
You can power your scanner using either the supplied DC power cord or from your vehicle’s cigarette