User's Manual

20-496 Owner’s Manual Draft Page 22/78
7. While S in Step blinks, repeatedly press ^ or v to select the step number, 5, 6.25, 7.5, 12.5, 15, 25.0, or
50.0kHz, and then press ENT.
PROGRAMMING MOTOROLA 800 MHz SPLINTER SYSTEMS
Certain 800 MHz Motorola trunked radio systems operate using splinter channels that are in between the
channels in the normal 800 MHz band plan. These systems are known as “splinter systems”. Your scanner
features an offset mode to allow reception of these systems.
Notes:
. If the radio appears to be trunking to the wrong frequencies when monitoring an 800 MHz system, you
should try to configure the system for splinter operation.
. Splinter systems exist only in the 800 MHz band, and only use the 3600 bps control channel type. Setting
splinter configuration on VHF, UHF, 900 MHz and 800 MHz APCO-25 systems will have no effect.
1. Press PROG, and then TRUNK to enter the ID program mode.
2. If necessary, press FUNC then ^ or v to select the desired bank.
3. If necessary, press MODE to select Motorola trunking mode.
4. Press FUNC , and then 3 to edit the 3600 CC Mode.
5. Press ^ or v to select Normal, Splinter, Table, or Multi Table, and then press ENT.
Programming Fleet Maps
You must set the fleet map if you want to receive a Motorola Type I system. Fleet maps are included along
with other information about Motorola Type I systems at www.trunkscanner.com
Follow these steps to program a fleet map.
1. Press PROG, and then TRUNK.
2. Press FUNC, and then ^ or v to select the desired bank.
3. Press FUNC, and then press 8. Block 0 size code. Use 15 for type II. S-00 is displayed.
4. Enter the size code supplied with the Type I system information, referring to the prompts that appear in
the display. If the information for your Type I system is not available, try the following common fleet maps:
Notes: