User's Manual

20-496 Owner’s Manual Draft Page 39/78
USING FREQUENCY COPY
You can easily copy a frequency into a specified channel, a vacant channel in a specified bank, or a priority
channel. This feature provides and easy method of storing frequencies of interest you encounter while
searching or tuning.
Note: You cannot copy a frequency from the Marine search bands.
COPYING A FREQUENCY INTO A SPECIFIED CHANNEL
You can copy a frequency into a specified channel when the scanner stops on that frequency during search
mode or manual tuning. If a CTCSS or DCS code is detected on the transmission, the detected code will be
copied into the channel memory as well.
Note: If you try to copy a frequency that is already stored, the scanner sounds the notice tone 3 times after
you press ENT. Dupl.f Chxxx appears at the bottom line. If you want to copy the duplicate frequency
anyway, press ENT, or if not, press CLEAR to cancel.
1. Press FUNC, and then PROG when you find a frequency. Chan Store? appears on the bottom line. After
about 1 second, the frequency to be copied flashes on the indicator.
2. Press the desired bank and the channel number where you want to store the frequency. The display
indicates the bank and channel number, and briefly displays the frequency that is currently programmed
into the selected channel. You can repeat this step as needed until you find an acceptable destination
channel. After about 1 second, the frequency to be copied flashes.
3. Press ENT. All the conditions such as receive mode and delay condition are copied onto the channel.
Chan Store! briefly appears in the scanner’s display. The scanner automatically returns to search mode.
COPYING A FREQUENCY INTO A VACANT CHANNEL IN A SPECIFIED BANK
You can copy a frequency into a vacant channel in a specified bank when the scanner stops on the
frequency during search or tune mode.
Note: If you try to copy a frequency that is already stored in the same bank, the scanner sounds the notice
tone 3 times after you press ENT. Dupl.f Chxxx appears at the bottom line. If you want to copy the duplicate
frequency anyway, press ENT, or if not, press CLEAR to cancel.
1. Press FUNC, and then ENT when you find a frequency you want to copy. Bank9 Store? appears in the
scanner’s display.
2. If you want to copy the frequency into bank 9, press ENT. It is stored in the first available vacant channel
in the bank. Or, press your desired bank number to store, then press ENT to store the frequency in the