User's Manual

20-496 Owner’s Manual Draft Page 50/78
PRO-96 scanner using an optional connecting cable with 1/8-inch (3.5 mm) phone plugs on both ends (use
RadioShack part number 42-2420 available at your local RadioShack store), or to a computer application
designed to work with this scanner using a PC interface cable (use RadioShack part number 20-289,
available at your local RadioShack store).
Notes:
. CLONE MODE Incorrect Model appears if the scanner receives data from another scanner other than a
PRO-2096 and PRO-96.
. This scanner can send/receive the data to or from a PRO-96 scanner. But Right (PRO-96) and Dimmer
(PRO-2096) setting does not transfer. There are to set the default setting.
Follow these steps to clone the data.
1. Turn on both scanners.
2. Connect the connecting cable to each scanner’s PC/IF jack. *CLONE MODE* UP to send, Remove
Cable to Exit appears in the scanner’s display.
3. Press ^. Confirm send data? 1=YES Press other key for NO. appears in the scanner’s display.
4. Press 1 to send the data to the other unit or press any other key to cancel the operation.
5. The scanner sends the data. Do not disconnect the PC/IF cable or interrupt power to either scanner
while the transfer is taking place.
6. To exit the clone mode, remove the cable.
CLONING V-SCANNER DATA
Your PRO-2096 Digital Scanner supports cloning of both working memory and V-Scanner memory to and
from other PRO-2096 and PRO-96 scanners or PC application software. This section describes the
process of cloning V-Scanner memory between two radios.
Two types of V-Scanner memory clone are supported. Full Clone transfers all V-Scanner folders from one
PRO-2096 (the “source” radio) to a second PRO-2096 or PRO-96 (the “destination” radio). Selective Clone
transfers selected V-Scanner folders from a “local” controlling radio to a “remote” slave radio.
CAUTION: The Full Clone feature should be used with caution – it overwrites all V-Scanner memory in the
destination radio with the contents of the V-Scanner memory in the source radio. This operation cannot be
undone.
Performing a Full Clone