User's Manual

20-496 Owner’s Manual Draft Page 69/78
SQ is not adjusted properly. Turn SQ clockwise until scanning
resumes.
--------------------------------------------------------------------------------------------------------------------------------------
The scanner does not The digital channel or talkgroup is The scanner can only receive
receive digital not using APCO-25 digital APCO-25 C4FM IMBE digital
transmissions on digital modulation. signals.
frequencies or trunking --------------------------------------------------------------------------------------------------
systems. The digital channel or The scanner will not receive
talkgroup is encrypted. encrypted traffic.
-------------------------------------------------------------------------------------------------
The digital channel or talkgroup is Reposition the scanner or use an
being transmitted from a distant outdoor antenna to improve
location. reception.
--------------------------------------------------------------------------------------------------------------------------------------
RESETTING/INITIALIZING THE SCANNER
If the scanner’s display locks up or does not work properly after you connect a power source, you might
need to reset or initialize it.
IMPORTANT: If you have problems with the scanner, first try to reset it to retain all memory. If that does not
work, you can initialize the scanner. You may be able to save the information in your scanner’s memory into
your computer, a V-Scanner folder or another scanner before trying to initialize it. See “Cloning the
Programmed Data” on Page XX and “Working with V-Scanners” on Page XX.
Resetting the Scanner
1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper clip, into the reset hole on the back of the scanner.
Then gently press and release the reset button inside the opening.
Note: Pressing the reset button does not clear the scanner’s working memory or the V-Scanner folders.
Initializing the Scanner
IMPORTANT: Initialilzing the Scanner clears all information you stored in the scanner’s working memory.
Initialize the scanner only when you are sure the scanner is not working properly. V-Scanner memory is not
affected when the scanner is initialized.
1. Turn off the scanner, then turn it on again. The scanner briefly displays the DSP boot version, and then
Welcome To Digital Trunking appears.