User's Manual

storage bank and channel, and press MAN to advance to that channel.
Note: For direct channel entry, press MAN, enter the channel storage bank (0-9) and channel number (00-49)
where you want to store a frequency, then press MAN again, For example, Bank 3, Channel 23 is entered as
"323". The scanner advances to the selected channel storage bank and channel, and the channel storage
bank and channel number appear at the top of the display.
2. Use the number keys and ./CLEAR to enter the frequency (including the decimal point) you want to store.
3. If you make a mistake, press and hold ./CLEAR for about 2 seconds to clear the entire field and start over.
4. Press ENT to store the frequency into the channel.
Notes:
. If you made a mistake in entering the frequency, Invalid Freq. briefly appears and the scanner beeps when
you press ENT. Enter the frequency again.
. Your scanner automatically rounds the entered frequency to the nearest valid freequency. For example, if
you enter a frequency of 151.53, your scanner accepts it as 151.5275. Reception of the frequency will not be
adversely affected.
. If you enter a frequency that has already been entered elsewhere in the same bank, the scanner sounds an
error tone and displays Dupl.Freq. and the channel number that has been duplicated. If the dual entry is an
error press ./CLEAR and enter the correct frequency. If the dual entry is intentional press ENT to accept.
. You may replace any frequency by selecting the bank and channel, pressing MAN and entering the new
frequency.
. You can clear programmed frequency data, press 0 then press ENT.
5. By default, the scanner will configure the channels you enter for a two second delay after a transission is
received. This is indicated by the D character that appears in the top row of the display. If you do not want the
scanner to pause for reply traffic before resuming scanning operation, press FUNC then 2/DLY until D is not
visible in the top line of the display.
6. If necessary, press FUNC then press 4/CTCSS to program the CTCSS code.
Storing Text Tags
You can customize your scanner by storing text tags (up to 16 characters) for easy identification of channel
transmissions.
1. Press and hold FUNC about 2 seconds. Menu appears.
2. Press 2 then press 2 again to enter normal channel program mode.