User's Manual

20-527 Owner’s Manual Draft
Page 43 of 60
0 S11 S4 S4 S12 S4 S3 S10 S1
1 S11 S4 S4 — S4 S10 S10 S1
2 S11 S4 S4 S4 S12 S4 S11 S2
3 S11 S4 S4 S4 — S4 S4 S2
4 S11 S4 S4 S4 S4 S12 S4 S3
5 S11 S4 S4 S4 S4 — S4 S3
6 S11 S4 S12 S4 S4 S12 S4 S4
7 S11 S4 — S4 S4 — S4 S4
9 10 11 12 13 14 15 16
0 S4 S0 S4 S0 S3 S4 S4 S3
1 S4 S0 S0 S0 S3 S3 S4 S10
2 S0 S0 S0 S0 S11 S10 S4 S10
3 S0 S0 S0 S0 S4 S4 S11 S11
4 S0 S0 S0 S0 S4 S4 S11 S0
5 S0 S0 S0 S0 S0 S4 S0 S0
6 S0 S4 S0 S0 S0 S12 S12 S12
7 S0 S4 S0 S4 S0 — — —
5. Press ENTER for each entry. If you make a mistake, press CL and enter the correct size code.
Notes:
• The default setting of the bank is for Motorola Type II. However, if you set Type I and you want to return
to Type II, enter 15 at Step 4.
• To confirm the input, repeat Steps 1-5 and press ENTER. Each time you press ENTER, you confirm the
size code. If you find an error, press CL and begin again at Step 1.
6. Press SCAN to start scanning.
Talk Group IDs
There are 10 talk group ID banks and each ID bank has 5 sub-banks. Each sub-bank has 30 ID locations.
You can program up to 150 talk group IDs in each bank, so you can program up to 1,500 talk group IDs in
10 banks. When the scanner stops on a transmission in the Motorola, EDACS, or LTR mode, it checks to
see if the ID has been stored. In the closed mode, the scanner only stops on the transmission and
displays its text tag if you have stored and not locked out the ID. In the open mode, the scanner always
stops on a transmission, but it displays the ID’s text tag if you have stored the ID.
Storing Talk Group IDs
To store a talk group ID, press TRUNK when the scanner stops on a voice channel transmission or when
a talk group ID is indicated in the manual mode. The bottom line indicates where the ID was stored as ID