User’s Handbook TA100 S m a r Ta ch + Tachometer and Ignition Analyzer
Table of contents. 2. TECHNICAL SPECIFICATIONS 1. Safety Rules Page 1 2. Technical Specifications Page 2 2.1 General specifications 2.2 Electrical specifications Page 2 Page 2 3. Operation Page 3 3.1 Instrument description 3.2 LCD Display 3.3 Buttons description and operation 3.4 Measurement procedures 3.5 Additional functions 4. Application information 4.1 Single cylinder RPM measurement 4.2 Wireless RPM measurement 4.
.1 Instrument Description 1) 2) 3) 4) 5) 6) 7) 8) 9) MIN - Minimum reading • Hold and displays the minimum value of the measurements, with the last digit rounded to ‘0’. The minimum value is automatically reset when turning the unit off or manually by momentarily pressing the ‘Power On/Off / Reset’ button.
3.3.4 Cylinders Increase and Decrease buttons 3.4.1.2 Wireless RPM measurement • Each time the ‘Cylinder Increase’ button is pressed, the number of cylinders will be increased, and the selected number of cylinders will be shown on the display. • When the KV Adjust mode is activated, this button is used to increase the Peak KVolt scale setting. • Each time the ‘Cylinder Decrease’ button is pressed, the number of cylinders will be decreased, and the selected number of cylinders will be shown on the display.
3- Press and hold the (Engine Cycles / KV Adjust) button until the minimum reading in the display is replaced by ‘KV Scale” and then a number followed by a ‘%’ sign, as shown in Fig. 4 below. 4- While holding the (Engine Cycles / KV Adjust) button pressed, use the Increase) or (Cylinders Decrease) buttons to adjust the scale value. Cycles KV Scale (Cylinder Cylinders % Peak Notes: Fig.
3- Observe the ignition peak voltage reading of the display. Some jumping of the readings is normal and reflects actual changes in the peak voltages of the ignition system. 4- Record or memorize the maximum, minimum and average reading. Repeat the test for each of the spark plug wires of the engine and note any readings that are significantly higher or lower than the average. 5. MAINTENANCE 2.
Part # TA100MN1201EN To visit our website, scan the QR code below with your smart phone Or type in your browser: www.gtc.ca General Technologies Corp. #121 - 7350 72nd Street Delta, BC Canada V4G 1H9 Tel.: (604) 952-6699 Fax: (604) 952-6690 email: info@gtc.ca © 2010 General Technologies Corp.