Owner manual
#',!&#'"!&
Accommodates stock from 1/2 in. to 1 in. thick.
*'O&!''
The fully assembled jig
One 14° x 1/2 in. dovetail router bit
with guide bearings (1/4 in. shank)
One alignment tool
One allen wrench
Face Clamp
Thumb Screws (4)
Face Clamps (4)
It is highly recommended
that you familiarize
yourself with the
nomenclature in Fig. 3
before proceeding.
FIG. 3
DOveTaIl JIG asseMBlY
1. Remove all components from hardware bag and ensure that all are present and undamaged.
2. Install thumb screws into tapped holes as shown. Screw locations may be adjusted as
needed. (FIG. A)
3. Press non-marring ends onto thumbscrews. (FIG. B)
FIG. A
FIG. B
860 Dovetailer Manual R4-120811_awb 12/8/11 3:07 PM Page 4