Project Ideas

50
General Tools & Instruments
Tubing Benders & Gages
SPECIALTY HAND TOOLS
TUBING BENDERS – S016
• These tools eliminate crimping and collapsing
of copper and other thin wall tubing. Made of
oil hardened and tempered spring steel
• Tubing bender set contains one each of the
sizes listed below, packaged in a display box
• Available in individual sizes
TUBE SIZE
UPC NO. OUTSIDE DIA.
11009 1 S106 1/4", 5/16", 3/8",
7/16", 1/2", 5/8"
TUBE SIZE
NO. OUTSIDE DIA. LENGTH
100-1/4 1/4" 10-1/2"
100-5/16 5/16" 10-1/2"
100-3/8 3/8" 10-1/2"
100-7/16 7/16" 10-3/8"
100-1/2 1/2" 11-3/4"
100-5/8 5/8" 11-3/4"
S106
151
• High quality tool moderately priced
• Screw yoke slips quickly over bars without
removing heavy-duty wing nuts
• Yoke has a freewheeling 45° plated cone for
faster, smoother flaring and greater strength in
flaring copper, aluminum, brass and thin wall
tubing
• Large heavy-duty hardened feed thread for
durability
• Long sliding T-handle provides maximum
leverage
• Quick opening plated bars for easy insertion
and removal of tubing
• Size individually marked on bars
• Extra long bars to fit in vice, for easier flaring
• Cast iron yoke
UPC NO. CAPACITY
14008 1 151 3/16", 1/4",
(Standard) 5/16", 3/8",
7/16" 1/2", 5/8"
• General’s drill gages are used to quickly and
conveniently identify drill bit sizes
• Made of heat treated heavy gage steel,
machined and ground to close tolerances
• Hole sizes and decimal equivalents are
permanently marked on the face
• 3" x 1-1/8" wide.
UPC NO.
22006 6 13 Number size drills 61 to 80
13
20
WIRE GAGE – 20
• American Standard wire gage 0 to 36
• For gaging non-ferrous wire and metals such as
copper, brass and aluminum
• Decimal equivalents of each size are stamped
on reverse side
• Satin finished, heavy gage hardened and
tempered steel
• 3-1/4" diameter, 3/32" thick
UPC NO.
22036 3 20
SHEET METAL GAGE – 21
• Gage numbers are U.S. Standard 0 to 36
• For gaging uncoated sheet metal, plate iron and
steel
• Decimal equivalents of each size are stamped
on reverse side
• Satin finished, heavy gage steel is hardened
and tempered
• 3-1/4" diameter, 3/32" thick
UPC NO.
22041 7 21
21
DRILL GAGE – 13
FLARING TOOL – 151