Specification Sheet

ManualsBrandsGeneral Wire ManualsElectric HeatersCold-Shot™ Pipe Freeze Kit

Cold-Shot

™

Operating Instructions

For 1/8” through 2” metal and plastic lines

(10mm—60mm)

Your Cold-Shot is designed to give you

years of trouble-free, profitable service.

However, no machine is better than its op-

erator.

Read, understand and follow all safety

warnings and instructions provided with

the product. Failure to follow the warnings

and instructions may result in electric

shock and/or serious injury. Save all warn-

ings and instructions for future reference.

SAVE THESE INSTRUCTIONS!

Summary of content (6 pages)

PAGE 1
M Cold-Shot™ Operating Instructions For 1/8” through 2” metal and plastic lines (10mm—60mm) Your Cold-Shot is designed to give you years of trouble-free, profitable service. However, no machine is better than its operator. Read, understand and follow all safety warnings and instructions provided with the product. Failure to follow the warnings and instructions may result in electric shock and/or serious injury. Save all warnings and instructions for future reference.
PAGE 2
Cold-Shot™ GENERAL SAFETY RULES Always wear safety glasses and rubber soled, non-slip shoes. Use of this safety equipment may prevent serious injury. WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury. Replacement manuals are available upon request at no charge, or may be downloaded from our website, www.drainbrain.com.
PAGE 3
Cold-Shot™ Work Area 7. Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of untrained users. 1. Keep work area clean and well lit. Cluttered benches and dark areas invite accidents. 8. Maintain tools with care. Replace worn parts as early as possible. 2. Do not operate within two feet of open flame. Heat source within close range of the metal pipe could melt ice plug, causing catastrophic failure and severe water damage 9.
PAGE 4
Cold-Shot™ Note: If only one freeze head is needed, use locking nut to close half of the T-distributor. FEATURES Carrying Case Instruction Manual Rubber Gloves 4. Choose freeze heads which correspond to the size of the pipe to be frozen. 5. Place the freeze heads on the pipe and secure by tightening the knobs evenly, using the hex head wrench provided, to give a firm, but not overly tight, hold.
PAGE 5
Cold-Shot™ 5. While work is in progress, the flow of carbon dioxide refrigerant must be maintained. To ensure a sufficient supply of refrigerant is available, a stand-by cylinder is suggested. The only way to determine the amount of remaining carbon dioxide is to weigh the cylinder. If it is necessary to change the cylinder during work, it is essential that this procedure should be completed within 7 minutes to prevent the ice pack from melting. 3.
PAGE 6
Cold-Shot™ TROUBLE SHOOTING GUIDE Problem Cause Solution Liquid won’t freeze Liquid still flowing. All liquid flow must be stopped. Pipe not full. Pipe must be full of liquid to create a solid plug when frozen. Incorrect CO2 tank Must use CO2 tank with dip tube. CO2 cannot get to freeze head due to clogged filters. Check and replace clogged filters in the T-Distributor or Injectors. Glycol or antifreeze in pipe. Flush line with water before freezing. Freeze head will not seal tightly.