User guide

ManualsBrandsGeneralAire ManualsAir purifiersGUV2018

1. Cut out shaded area of template (#1) or for high heat installations, cut on the dotted line. (#2)

2. Place template on the return path of the HVAC system and trace the hole pattern for the unit and mark centers for mounting screws.

3. Drill one 9/64” hole at each of these locations for sheet metal screws.

4. Cut opening for the unit.

5. Install unit into air duct using the four sheet metal screws provided.

(Page Insert)

INSTALLATION TEMPLATE

Cut out on dashed line.

(Opening size is 6.75” x 2.5”)

TOP

ENERAL

IRE

GUV 2018

Summary of content (5 pages)

PAGE 1
. 2. 3. 4. 5. (Page Insert) INSTALLATION TEMPLATE #1 Cut out on dashed line. (Opening size is 6.75” x 2.5”) GENERALAIRE GUV 2018 Cut out shaded area of template (#1) or for high heat installations, cut on the dotted line. (#2) Place template on the return path of the HVAC system and trace the hole pattern for the unit and mark centers for mounting screws. Drill one 9/64” hole at each of these locations for sheet metal screws. Cut opening for the unit.
PAGE 2
TROUBLESHOOTING • Under normal operation the LED should light when the unit has been supplied power. If the LED does not light: 1. Check to be sure there is power to the unit. 2. Be sure lamp connector is fastened securely. 3. If the LED still does not light, replace lamp. 4. If still not operating, replace ballast. WARRANTY The manufacturer warrants the GUV-161 air purification unit against defects in materials and workmanship for a period of four (4) years from the date of installation.
PAGE 3
GENERALAIRE GUV-2018 Dual Voltage Phototcatalytic Air Purifier Installation & Maintenance Instructions UNPACKING THE UNIT Each GeneralAire GUV-2018 Air Purifier unit is shipped with the germicidal lamp p laced i n a tube with p rotective packaging. Carefully r emove lamp f rom t he t ube taking care to not t ouch the g lass portion with bare hands. Oils from the hands can cause “hot spots” which reduce lamp life. Handle by the porcelain caps or use a soft cloth.
PAGE 4
INSTALLATION • Best results are achieved when the unit is installed where the HVAC air temperature is most constant. Therefore, the preferred installation return side of the furnace. If return side installation is not possible, install the unit on the supply side, keeping it as far from the heat/cooling source as possible, and in the main airstream. • Do not locate the unit within 20” of any plastic material that will be exposed to the UV light, such as a return side humidifier or certain filters.
PAGE 5
WIRING Simply plug the unit into an 120 VAC outlet and allow it to run continuously. The ballast is factory set at 120 VAC. For installations that require 240VAC locate the 120 / 240 volt power selector on th e ballast and set for the correct voltage. (Photo A) Remove plug and wire in accordance with local wiring codes. MAINTENANCE This maintenance schedule is only a guideline, determined by average conditions. Actual conditions will dictate the frequency of cleaning and/or replacement of lamps.