Manualshelf

Instructions / Assembly

ManualsBrandsGeneration Lighting Designer Collections ManualsChandeliersED Ellen DeGeneres Crafted by Generation Lighting Brisbin 24 in. W 1-Light Burnished Brass 3-Tiered Shades Metal Pendant
12
1
Installation Instructions for
Brisbin 1 Light Pendant
1.0
EP1021
Pendant
EP1021
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Install the shades to their corresponding frames. Install the lower shade from the bottom of the socket assembly, then install the
small and large shades from the top of the socket assembly (in that order) followed by the upper shade. See figure 1 for details.
Screw the half ball to the stem which will be on top.
Determine the wanted height or look of the fixture with the provided stems, then assemble them by screwing them together.
Feed the fixture wires through the spacer and stem assembly, then screw the stem assembly to the top of the socket assembly.
Feed the fixture wires through the collar nut, canopy and half ball assembly, then screw it onto the stem assembly.
Align and secure the mounting plate to the junction box, then slide the half ball assembly onto the mounting plate.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate and secure it in place by screwing the
collar nut tightly onto the mounting plate.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
4
5
6
7
8
9
10
11
9
STEM ASSEMBLY
CANOPY
HALF BALL ASSEMBLY
MOUNTING PLATE
JUNCTION BOX
STEM
HALF BALL
COLLAR NUT
4
5
8
SOCKET ASSEMBLY
LARGE
SHADE
SMALL
SHADE
UPPER
SHADE
LOWER
SHADE
FIGURE 1
SPACER
LAMP
11

Summary of content (2 pages)