Instructions / Assembly

1
Installation Instructions for
Secure the mounting plate to the junction box. NOTE: For Model EW1001, use a 2x4 junction box.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Screw the lamp(s) into the socket(s). Refer to the label on the socket for max wattage information.
OPTIONAL: Install the shade by carefully placing it over the socket and onto the shade base. Repeat for remaining shades if
necessary.
1
2
3
1A
4
5
Brianna 1 and 2 Light Wall
1.0
EW1001-EW1002
EW1001, EW1002
Wall
JUNCTION BOX
(FOR MODEL EW1002)
MOUNTING
PLATE
4
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
6
SHADE (OPTIONAL)
3
7
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
FIXTURE SCREW
LAMP
SOCKET
6
5
5
7
JUNCTION BOX
(FOR MODEL EW1001)
STANDARD
JUNCTION BOX
2" x 4"
JUNCTION BOX