Installation Guide

1
Installation Instructions for
Asher 3 Light Flush Mount
1.0
EF1003
Ceiling
EF1003
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the fixture base and washer onto the threaded nipple, and secure them in
place by screwing the hex nut onto the nipple followed by the cap nut.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
Insert the diffuser into the shade, align the brackets with the holes on the top of the shade, and secure them together using the
diffuser screws.
Align the shade with the slots on the fixture base, then secure them together using the shade screws.
4
5
6
JUNCTION BOX
4
3
LAMP
FIXTURE BASE
MOUNTING PLATE
SLOT
WASHER,
HEX NUT, &
CAP NUT
DIFFUSER
SHADE
SHADE SCREW
DIFFUSER SCREW
BRACKET
7
8
7
8
8
7
MOUNTING STUD
6
5