Installation Guide

ManualsBrandsGeneration Lighting ManualsLightingJamestowne 1-Light Black Outdoor Traditional Lamp Post Light Top

INSTALLATION AND SAFETY INSTRUCTIONS

FOR YOUR SAFETY ASSEMBLY

ITEM #

GENERAL

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF .

You don’t need special tools to install this fixture. Be sure to follow the

steps in the order given. Under no circumstances should a fixture be

hung on house electrical wires, nor should a swag type fixture be

installed on a ceiling which contains a radiant type heating system.

Read instructions carefully.

If you are unclear as to how to proceed,

consult a qualified electrician.

NOTE: Proper wiring is essential for the safe operation of this

fixture.

Attach finial [A] to top assembly [B] of fixture (if not factory installed).

NOTE: Your handcrafted, solid brass lighting

fixture has been coated with a durable, baked-on

acrylic lacquer which gives maximum protection

against the weather. In time however, the

brightness of the brass will tarnish giving way to an

authentic old world brass finish.

NOTE: To keep your solid polished brass fixture

looking new for years to come, regularly apply a good

quality non-abrasive car wax to all metal surfaces,

giving the fixture an extra protective coating.

Fill in item number located on carton and file this sheet for

future reference

HC-234

012405

(FIG. 1)

STEP 1:

CAGE (D)

FITTER (E)

SCREWS

FINIAL (A)

TOP

ASSEMBLY (B)

SCREWS (C)

WARNING

NOTE: DO NOT INSTALL ON A POST OR A POLE THAT

RESULTS IN A VERTICAL RISE OF 25 FEET OR HIGHER.

Carefully remove the fixture from the carton and check that all

parts are included, as shown in Figure 1 & 2. Be careful not to

misplace any of the screws or parts which are needed to install

this fixture.

NOTE: This glass is handcrafted, the slight imperfections in

the glass add to the authenticity of the fixture.

NOTE: Be sure that all sections of top finial are

securely tightened to prevent water seepage into

the fixture

CAUTION:

Fixtures with photo-cells should be mounted at least 48”

from all sides to avoid reflection of light back onto Photo-cell,

causing the Photo-cell to malfunction or flicker.

Summary of content (2 pages)

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS FOR YOUR SAFETY ASSEMBLY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF . GENERAL Carefully remove the fixture from the carton and check that all parts are included, as shown in Figure 1 & 2. Be careful not to misplace any of the screws or parts which are needed to install this fixture. STEP 1: You don’t need special tools to install this fixture.
PAGE 2
INSTALLATION HC-234 STEP 1: A. Take note of the color of the wire(s) on your fixture. Identify which group your fixture wire(s) falls into and connect the wires according to the directions below: STEP 2: GROUND INSTRUCTIONS: Connect the ground wire from the fixture (bare metal or green insulated wire) to the ground wire from the power supply (bare metal or green insulated wire) using a small wire connector (not supplied). NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES.