Manualshelf

Installation Sheet

ManualsBrandsGeneration Lighting ManualsC&M By Chapman & MyersGeneration Lighting Southold 4 Light 28" Wide Taper Candle Chandelier
12
1
Installation Instructions for
1.0
C 1003C
C 1003, C 1014, C 1024, CC1044CCC
If necessary, screw the short end of the threaded nipple tightly onto the mounting plate and the screw collar onto the threaded nipple.
Secure the mounting plate to the junction box.
Install the candle tube by sliding it over the socket.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Feed the cord through the frame top and the fixture loop, then screw the fixture loop into the frame stem.
Screw the frame arms into the frame bottom, then place the sleeves over the frame arms.
Place the frame top on to the frame arms and secure in place with the frame screws.
Determine the wanted height of the fixture and remove a portion of the chain from the bottom by opening a link with pliers.
Install a quick link to bottom end of the chain, then secure the quick link onto the fixture loop.
Unscrew the collar nut from the screw collar, then install the collar nut, and the canopy onto the chain (in that order).
Install the other quick link onto the remaining end of the chain, then secure the quick link onto the screw collar.
Weave the cord through the chain, collar nut, canopy, threaded nipple, and out of the junction box. Trim the cord leaving enough to
make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place by screwing the collar
nut onto the screw collar.
1
2
1A
3
4
Southhold Lantern
Pendant
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
5
6
7
8
9
10
11
12
13
14
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
15
COLLAR NUT
CHAIN
THREADED NIPPLE
MOUNTING PLATE
15
14
SCREW COLLAR
CANDLE TUBE
QUICK LINK
JUNCTION BOX
12
9
LAMP
FRAME SLEEVE
FIXTURE LOOP
5
FRAME ARM
QUICK LINK
CANOPY
SOCKET
10
4
3
FRAME SCREW
FRAME BOTTOM
FRAME TOP
FIXTURE STEM
16
6
7
8

Summary of content (2 pages)