Manualshelf

Installation Sheet

ManualsBrandsGeneration Lighting ManualsC&M By Chapman & MyersGeneration Lighting Stonington 4 Light 18" Wide Taper Candle Pendant
12
Installation Instructions for
1.0
C 1094C
C 1094C
Stonington Pendant
Pendant
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
Secure the mounting plate to the junction box.
Install the candle tube by sliding it over the socket.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Feed the cord through the threaded nipple, cap and fixture loop.
screw the fixture threaded nipple to the fixture then place the cap over the threaded nipple an secure by screwing the fixture loop
onto threaded nipple.
Determine the wanted height of the fixture and remove a portion of the chain from the bottom by opening a link with pliers.
Install a quick link to bottom end of the chain, then secure the quick link onto the fixture loop.
Install the other quick link onto the remaining end of the chain, then secure the quick link onto the canopy loop.
Weave the cord through the chain, canopy and out of the junction box. Trim the cord leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place by using the
provided canopy screws.
1
2
1A
3
4
5
6
7
8
9
10
11
12
CHAIN
MOUNTING PLATE
12
11
CANDLE TUBE
JUNCTION BOX
7
LAMP
FIXTURE LOOP
4
FIXTURE
QUICK LINK
CANOPY
SOCKET
8
3
2
CANOPY LOOP
QUICK LINK
CANOPY SCREW
9
CAP
THREADED NIPPLE
13

Summary of content (2 pages)