Installation Guide

Kinsale Wall

1.0

C 1252W

WALL

Installation Instructions for

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with

the construction and operation of the product and the

hazards involved.

Use minimum 90°C supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC

compliant junction boxes.

This product is safety listed for damp locations.

Incandescent version may be dimmed with a standard

incandescent dimmer. LED version may be dimmed with a LED

dimmer. Consult lamp manufacturer for additional information.

This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.

7400 Linder Ave., Skokie, IL 60077

T 847.410.4400 | F 847.410.4500

www.generationlighting.com

PAGE 1
CW1252 Installation Instructions for Kinsale Wall CW1252 1.0 WALL GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for damp locations. Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information. This instruction shows a typical installation.
PAGE 2
Install the Fixture 1A 4 HOOK LAMP SOCKET CANDLE TUBE 3 SOCKET MOUNTING PLATE CRYSTAL SMALL CRYSTAL HOOK SOCKET CUP 7 CRYSTAL 6 SET SCREW 8 LARGE CRYSTAL ALLEN WRENCH 1 Secure the mounting plate to the junction box. 2 Install the crystals on the fixture as shown. 3 Install the candle tube by sliding it over the socket. 4 Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.