Installation Sheet

1
Installation Instructions for
For Models OL13701, OL13702, and OL13703 Only: Temporarily install the mounting plate to the junction box.
For Models OL13701, OL13702, and OL13703 Only: Mark the anchor hole locations on the mounting plate and remove the
mounting plate.
For Models OL13701, OL13702, and OL13703 Only: Drill appropriate size holes at the marked locations and install the
anchors.
Secure the mounting plate to the junction box.
For Models OL13701, OL13702, and OL13703 Only: Screw the anchor screws into the anchors.
Insert the glass panels into the fixture and secure them in place using the clips.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
1
2
3
4
5
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.1
OL13700-OL13701-OL13702-OL13703-LED
O 13700, OL13701, O 13702, O 13703-L1LLL
Outdoor
1A
JUNCTION BOX
MOUNTING
PLATE
8
9
FIXTURE SCREW
6
7
8
11
FIXTURE
BASE
9
10
ANCHOR
ANCHOR
SCREW
11
Urbandale Outdoor Wall (LED)
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for wet locations.
3
5
GLASS PANEL
CLIP
6