Use and Care Manual

English

8” 5-Speed Drill Press

Operator’s Manual GDP500

Installing or Removing Bits (FIG 13)

WARNING: To reduce the risk of injury, only use the chuck key provided

with this drill press or a duplicate of it. This chuck key is self-ejecting and will

“pop” out of the chuck when you let go. This action is designed to help prevent

throwing of the chuck key from the chuck when power is turned “ON”. Do not

use any other key as a substitute; order a new one if damaged or lost.

To install a drill bit (FIG 13)























To remove the bit

WARNING: Make sure the chuck key is removed from the chuck before

starting any drilling operation.

Application

You may use this drill press for the following applications:







WARNING: Read and understand the following items about your drill

press before attempting to use it.

Position the Table and Work Piece













WARNING: Always make sure the work piece is not in contact with the

bit before operating the switch to start the tool. Failure to reed this warning

may cause the work piece to be kicked back toward the operator and result in

serious personal injury.

WARNING: Make sure the chuck key is removed from the chuck before

starting any drilling operation.

WARNING: Always make sure the work piece is secured to the table by

clamps or other clamping devices.

FIG 13