Use and Care Manual
English
10" Table Saw
Operator’s Manual GTS10SB
16
BLADE HEIGHT ADJUSTMENT (FIG 14)
90° AND 45° POSITIVE STOPS ADJUSTMENT
(FIG 14, 15, 16)
To Adjust 90° Positive Stop
To Adjust the 45° Positive Stop, follow the same
procedures as adjusting the 90 positive stop. Set
the blade at a 45° angle against a combination
square. The 45° positive stop adjusting screw
and jam nut (8) is on the right side. See FIG 16.
WARNING: To prevent personal Injury,
always unplug the saw from the power source
before make any adjustments.
BLADE BEVEL INDICATOR ADJUSTMENTS
(FIG 15, 17)
NOTE: Always make a trial cut on a piece of
wood when make critical cuts. Measure the cut
accuracy.
FIG 15
4
3 5
FIG 17
FIG 14
1
2
3
6
FIG 16
7 8