Use and Care Manual

English

BLADE BEVEL ADJUSTMENT (FIG 14)









 WARNING: Make sure bevel locking

lever is tightened before each use to avoid risk

of personal injury.

TO REPLACE THE BLADE (FIG 18)

WARNING: Always unplug the saw from

power source before maintenance to avoid risk

of serious personal injury.

To remove the blade:















To install the blade, reverse the procedure.

IMPORTANT:Blade rotation is clockwise when observing from the right side

of the saw. Make sure the rotation direction mark on blade matches with that.

OPERATION

 WARNING: DO NOT turn on the table

saw before clearing the table of all tools, wood

scraps, etc, except the work piece and related

feed or supporting devices.

ON/OFF SWITCH (FIG 19)











OVERLOAD RESET SWITCH (FIG 19)

WARNING:To prevent accidental startup if overload reset switch is

pushed, the ON/OFF switch must be in the OFF position and plug should be

removed from the power source while cooling down. Overheating may be

caused by dull blade or misaligned parts. Inspect your saw for proper setup

before using it again.







FIG 19

FIG 18