Use and Care Manual
21
English
WARNING:Never feed work piece through with your hands when
making non-through cut, such as rabbets or dados. Always use a push stick
and push block. Failure to do so can result in serious personal injury
IMPORTANT:The table saw is a highly versatile tool, capable of a wide
range of applications which cannot be covered in this manual. Do Not
attempt to perform cuts not covered in this manual unless you are thoroughly
familiar with procedures and featuring. Visit your local library for books on
woodworking techniques
OPTIONS
1-888-552-8665
TROUBLE SHOOTING
Problem Possible Cause Solution
Saw will not start 1. Saw is not plugged in 1. Plug into power source
2. Fuse blown or circuit breaker 2. Replace fuse or reset circuit breaker.
3. cord is damaged 3. Have power cord replaced by Authorized
Service Center
4. Debris in ON/OFF switch 4. Clean any accumulated debris
1. Positive stop not adjusted 1. Check the blade with square and adjust
2. Blade angle pointer not set
accurately
2. Check blade with square and adjust the Blade
angle pointer
1. Rip fence not aligned with blade 1. Check and adjust the rip fence
2. Warped wood, edge against
fence is not straight
2. Select another piece of wood
Material Binds on Splitter 1. Splitter not in line correctly with
blade
1. Check and align the splitter with blade
1. Dull Blade 1. Replace blade
2. Blade mounted backward 2. Turn blade around
3. Gum or resin on blade 3. Remove blade and clean
4. Incorrect blade for work 4. Change to correct blade
1. Rip fence out of adjustment 1. Align rip fence with miter gauge groove.
2. Splitter not in line with blade 2. Align splitter with blade
3. Feeding stock without rip fence 3. Install and use rip fence
4. Dull blade 4. Replace blade
5. Bevel Knob is not tight 5. Tighten the knob
Blade does not raise or tilt
freely
1 Sawdust and dirt in
elevation/tilting mechanisms
1. Brush or blow out loose dust and dirt
1. Extension cord is too light or too
long
1. Replace extension cord to adequate size
2. Low house voltage 2. Contact electrician
1. Saw not mounted securely to
work bench
1. Tighten all mounting hardware
2. Bench or stand on uneven floor 2. Re-position on flat level floor
3. Damaged saw blade 3. Replace blade
Does not make accurate 45°
and 90° rip cuts
Material Pinched Blade when
ripping
Saw makes unsatisfactory
cuts
Material Kicked Back from the
blade
Blade does not come up to
speed, Reset trips too easily
Saw vibrates excessively