User's Manual

Radio will stop for a programmed delay time and start scanning
on priority scan option activity channel.
- Look back (Receiving correct call in Priority scan mode)
Any channel, when not in the scan mode can be programmed to
“look back” at the priority channel. This feature is ideal for those
who do not need scan as defined above, but want to make sure
that they never miss a call on the “priority” channel if another
channel has been selected, the radio will periodically “look
back” at the Priority channel. If activity is detected on the
“priority” channel, the radio will move to that channel for as long
as it remains active.
- Priority Scan TX : If a coming signal is not correct call, allow
transmission on the normal channel. If a coming signal is a correct
call, allow transmission on the correct call channel. After finish
transmission, resume scan after scan delay time.
- Muti Scan : if press Scan key while Priority scan mode is On,
Priority Channel
scan and Normal scan will take place at the same time under this
condition,
scan sequence will be as below.
N-Ch(1) ===? P-Ch ==? N-Ch(2)===? P-Ch ===? N-Ch(3)……
4. TX operation
1) PTT TX
Allows transmission with pressing PTT.
2) To enable VOX function, first of all VOX function and its level
must be set through PC programmer and then turn Radio `
on while pressing PTT. At a moment, radio makes beep sound.
3) TOT (TX Time-out-Timer)
This function will be disable TX.