User Manual

Car2U
®
System Programming for GENIE Models
Programming Car2U to a Genie Opener
1. Press and hold the program button until the round blue LED and the long
blue LED are on – release the button. The round blue LED will be on.
2. Press the program button once - the long purple LED will begin flashing
3. Press a previously learned Intellicode
®
2 transmitter button
from model G3T
(
pictured ri
g
ht
)
one time. Both the lon
g
and round
LEDs flash purple.
4. Press the desired Car2U button for one second and release. Both the long and
round LEDs go solid purple.
5. Press the desired Car2U button (again) for one second and release. Both the long
and round LEDs change from solid purple to solid blue and then go out.
6. Pressing the Car2U button again will cause the garage door to move.
NOTE: If you cannot find your program button on the power head, see the user manual
for your opener or visit the Genie website for additional assistance.
2
IntelliG
®
1000, IntelliG
®
1200, TriloG
™
1200, TriloG
™
1500, GPower
™
900
Manufactured before July 2011
The label shown right is on the back of
the powerhead. Use this instruction if
the first 5 digits of the serial number
from this label is 11188 or smaller.
PRGM
PRGM