Manualshelf

User Manual

ManualsBrandsGenie ManualsBuilding SuppliesGenie ChainMax 1000 Garage Door Opener - 3/4 HPC DC Chain Drive Opener with Two 3-Button Pre-Programmed Remotes, Wall Console, Wireless Keypad and Safe-T-Beam Sensor System - Model 3022-TKH
123456
Car2U
®
System Programming for GENIE Models
Programming Car2U to a Genie Opener
1. Press and hold the program button until the round blue LED and the long
blue LED are on – release the button. The round blue LED will be on.
2. Press the program button once - the long purple LED will begin flashing
3. Press the desired Car2U button for one second and release. Press that same
button again for one second and release. The long LED will flash blue and then
turn off.
4. Pressing the Car2U button again will cause the garage door to move.
NOTE: If you cannot find your program button on the power head, see the user manual
for your opener or visit the Genie website for additional assistance.
3
IntelliG
®
1000, IntelliG
®
1200, TriloG
™
1200, TriloG
™
1500, GPower
™
900
Manufactured before November 2011
The label shown right is on the back of
the powerhead. Use this instruction if
the first 5 digits of the serial number
from this label is 11290 or smaller.
PRGM
PRGM