Manualshelf

User Manual

ManualsBrandsGenie ManualsBuilding SuppliesGenie ChainMax 1000 Garage Door Opener - 3/4 HPC DC Chain Drive Opener with Two 3-Button Pre-Programmed Remotes, Wall Console, Wireless Keypad and Safe-T-Beam Sensor System - Model 3022-TKH
123456
Car2U
®
System Programming for Genie Models
Programming Car2U to a Genie Opener
1. Press and hold the program button until the round blue LED is on –
release the button. The long LED will flash purple.
2. Press the desired Car2U button for one second and release. Press that same
button again for one second and release. The round LED and long LED will
both turn blue and then turn off.
3. Pressing the Car2U button again will cause the garage door to move.
NOTE: If you cannot find your program button on the power head, see the user manual
for your opener or visit the Genie website for additional assistance.
PRGM
4
IntelliG
®
1000, IntelliG
®
1200, TriloG
™
1200, TriloG
™
1500,
GPower
™
900, ReliaG
®
650, ReliaG
®
850
Manufactured after November 2011
The label shown right is on the back of
the powerhead. Use this instruction if
the first 5 digits of the serial number
from this label is 11291 or greater.