Replacement Part List

19
Adjusting Speed Control
Speed Settings (DC Models only)
Speed settings are pre-programmed at the factory for the maximum speed. Speed settings should
not need adjustment with this unit. However, travel speed for the opener can be adjusted to a slower
speed in both the Open and Close directions, to minimize wear on heavier sectional doors.
5IFSFBSFUISFFTQFFETFUUJOHTBWBJMBCMFGPSTFDUJPOBMEPPST
Please note that speed may be aected by door weight and balance, along with condition of door
components and tracks.
TO CHANGE OPENER TRAVEL SPEED:
1. Press and Hold the PRGM button until both LEDs turn BLUE, then release.
2. Press the UP button twice.
3. Press PRGM button once.
The current UP speed setting will now be displayed. (SEE CHART).
4. Press either UP or DOWN buttons to adjust speed (SEE CHART)
5. Press PGRM button once to lock in the UP travel speed.
The current DOWN speed setting will now be displayed. (SEE CHART).
6. Press either UP or DOWN buttons to adjust Down Travel Speed (SEE CHART).
7. Press PGRM button once to lock in the DOWN travel speed.
Opener is now ready to operate and test.
Operate door from the wall console two full cycles then perform safety contact reverse test.
(SEE PAGE 8)
SPEED SETTING CHART
Speed Level Long LED Round LED
HIGH RED RED
MED PURPLE PURPLE
LOW BLUE BLUE
PRGM
SET
PRGM
SET
BLUE
See Chart for Speed level
PRGM
SET
X2
PRGM
SET
PRGM
SET
Press to adjust. See
Chart for Speed level
PRGM
SET
PRGM
SET
See Chart for Speed level
Lock UP travel speed
PRGM
SET
Press to adjust. See
Chart for Speed level
PRGM
SET
Lock DOWN travel speed
1.
2.
3.
4.
5.
6.
7.