Replacement Part List

Step 1 Clear HomeLink

Clear HomeLink by pressing and holding down the rst and third buttons until the indicator on the

HomeLink blinks slow and then fast for 22 seconds; then release both buttons.

NOTE: Clearing the HomeLink will remove all previously programmed garage door openers.

Step 2 Train HomeLink to the Remote

Choose the button on the HomeLink that will be used to open the door.

NOTE:

Hold the Remote two inches from the HomeLink button.

Hold down the remote button. While holding, press and hold the chosen HomeLink button.

Hold down both buttons until the indicator on the HomeLink blinks slow then fast. Once it blinks, release

both buttons.

Programming HomeLink® System

Step 3 Program HomeLink to the Opener

(Place opener into programming mode)

A. Press and hold the PRGM button on the opener until the round blue LED is ON. Release the button. The long purple LED will

begin ashing.

PROGRAMMING VEHICLE CONTROLS (ABBREVIATED)

B. Press the chosen HomeLink button for two seconds and release. Press that same button again for two sec-

onds and release. The both LEDs will ash blue and then turn o.

C. Press the HomeLink button a few more times until door moves.

NOTE:

For additional instructions, see the motor vehicle manual, www.homelink.com or visit www.geniecompany.com

1. Press and hold the SET/PRGM button on the opener for

2-5 seconds.

• The ROUND LED will turn BLUE. Release button.

• The LONG LED will then ash PURPLE.

2. Complete programming steps.

PUTTING OPENER INTO PROGRAMMING MODE:

NOTE: The openers LEARN LED will time out in 30 seconds.

Programming must be completed within 30 seconds.

Solid Blue

PRESS

RELEASE

Flashing Purple