Replacement Part List

20
CLEARING MEMORY OF REMOTE CONTROLS
NOTE: Clearing memory of remotes from the powerhead will
clear ALL programmed remotes, wireless keypads and vehicle
transmitters. The opener will no longer recognize any signal
from any remote device, including a missing remote device.
This does not include the Aladdin Connect™ or Wireless Wall
Console.
All remaining (or recovered) remotes, vehicles and wireless
keypads MUST be reprogrammed.
1. Press and hold the SET/PRGM button on the
opener for 2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
• The LONG LED will then ash PURPLE.
2. Press and hold the UP & DOWN buttons 2-5
seconds until both LEDs turn BLUE then release.
Both LEDs will turn o indicating that all remotes
have been erased.
3. Press any remote button.
The opener should NOT run.
1. Enter Programming Mode
Solid Blue
Flashing Purple
2. Press and Hold UP & DOWN Buttons 2-5 seconds
3. Test Remote
Release when
LEDs turn BLUE
SPECIAL INSTALLATION INFORMATION
3. Test Wireless Wall Console
1. Enter Programming Mode
Solid Blue
Flashing Purple
2. Press and Hold UP & DOWN Buttons 10+ seconds
Release when
LEDs turn GREEN
1. Press and hold the SET/PRGM button on the
opener for 2-5 seconds.
• The ROUND LED will turn BLUE. Release button.
• The LONG LED will then ash PURPLE.
2. Press and hold the UP & DOWN buttons 10+
seconds until both LEDs turn GREEN then release.
Both LEDs will turn o indicating that all Wireless
Wall Consoles have been erased.
3. Press WALL CONSOLE button.
The opener should NOT run.
CLEARING MEMORY OF WIRELESS WALL CONSOLE