Instructions / Assembly
Wall Button Wire
Photocell wire
Power Pack
Aladdin Connect®
Control Wire
Quick Set-up Guide
®
DCM
(Door Control Module)
DPS
(Door Position Sensor)
Hardware Bag
Power Pack
Wire Spool
Insulated
Staple x30
WARNING
TO REDUCE THE RISK OF SEVERE INJURY
OR DEATH, READ AND FOLLOW ALL
INSTRUCTIONS.
1. NEVER let children operate or play with the
door controls.
2. Keep remote away from children.
3. Locate the wall control button: A) Within sight
of door. B) At a minimum height of 5 feet, so
small children cannot reach it.
4. Install the entrapment WARNING label next
to the wall button or console, in a prominent
location.
5. NO ONE SHOULD CROSS THE PATH OF THE
MOVING DOOR.
6. NEVER GO UNDER A STOPPED, PARTIALLY
OPEN DOOR.
7. The Aladdin Connect® operating system is
designed for unattended operation. The door
could move unexpectedly.
8. DO NOT install Aladdin Connect® on garage
door openers manufactured prior to 1993
without photocell non-contact safety sensors.
9. DO NOT install on one-piece doors
10. Install DCM in a location where it can be seen
and heard while standing in the door opening
with the door in the open position.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
AVERTISSEMENT
POUR RÉDUIRE LE RISQUE DE BLESSURES
GRAVES VOIRE MORTELLES, LIRE ET
COMPRENDRE TOUTES LES INSTRUCTIONS.
1. NE JAMAIS laisser les enfants utiliser ou jouer avec les
commandes de l’ouvre-porte.
2. Tenir les télécommandes hors de la portée des
enfants.
3. Localiser le bouton de la console murale: A) En vue
de la porte. B) À une hauteur minimale de 1,5m an
que les jeunes enfants ne puissent pas l’atteindre.
4. Placer l’étiquette d’AVERTISSEMENT en cas de
coinçage à proximité du bouton mural ou de la
console murale de manière à ce qu’elle soit bien en
évidence.
5. NE JAMAIS PASSER SOUS LA PORTE EN MOUVEMENT.
6. NE JAMAIS PASSER SOUS UNE PORTE À L’ARRÊT
PARTIELLEMENT OUVERTE.
7. Le système d’exploitation Aladdin Connect® a été
conçu pour fonctionner sans surveillance. La porte
peut se déplacer de façon inattendue.
8. NE PAS installer Aladdin Connect® sur les ouvre-
portes de garage fabriqués avant 1993, sans capteurs
de sécurité photoélectrique sans contact.
9. NE PAS installer sur les portes d’une seule pièce.
10. Installez DCM dans un endroit où il peut être vu et
entendu tout en se tenant dans l’ouverture de la porte
avec la porte en position ouverte.
CONSERVER CES INSTRUCTIONS
CONSIGNES DE SÉCURITÉ
IMPORTANTES
Included Components
Recommended Tools
Drill & 3/32 Bit
Small Common
Screwdriver
Phillips Head
Screwdriver
Wire Cutters/
Strippers
Hammer
5/16 Wrench or
Nut Driver
STEP 1
In the Home close to Wi-Fi Router:
“Wi-Fi router must meet these specications: 802.11
b/g/n, 2.4GHz with WPA2 or WPA Security”
1. Remove mounting bracket from back of DCM. FIG.A,
2. Plug Aladdin Connect® into wall outlet with Power Pack.
FIG. B.
3. Plug Power Pack into DCM controller.
STEP 2
In the Home close to Wi-Fi Router:
Download the Aladdin Connect® app.
1. Scan the QR code below or visit your devices app
store to start the setup of the Aladdin Connect® device.
Search your app store for Aladdin Connect
2. Follow the on-screen menus to create an account and
program system prior to wiring in the garage.
3. At the installation prompt, disconnect
Power Pack and move system to the garage.
WARNING
UNPLUG GARAGE DOOR OPENER PRIOR TO INSTALLING
ALADDIN CONNECT®
Door may operate unexpectedly.
AVERTISSEMENT
DÉBRANCHER L’OUVRE-PORTE DE GARAGE AVANT
D’INSTALLER ALADDIN CONNECT®
La porte peut fonctionner de façon inattendue.
STEP 3
In the Garage:
These factors must be determined prior to mounting Aladdin Connect®
(DCM) to the wall or ceiling.
1. Optimal Wi-Fi signal strength.
If an optimal signal cannot be located within the garage, move the wireless router
closer to the garage or install a Wi-Fi range extender
(Available from most electronic stores)
2. Desired DCM location.
3. Access to 110VAC outlet within 5 feet.
1. Plug Power Pack into wall outlet and DCM near the chosen mounting
location.
The WI-FI signal indicator LED should illuminate signaling that the Wi-Fi
signal is still in tact.
• A GREEN LED indicates a good Wi-Fi signal.
• A RED LED, indicates a lost or faulty signal.
Move Aladdin Connect® to a position that
better suits the Wi-Fi signal from the router.
Contact Customer Service for further
assistance. (1-866-599-4995)
2. Once an optimal signal and location is
obtained, UNPLUG Power Pack from the
DCM and continue to STEP 4.
Wi-Fi Signal Indicator
GOOD -- POOR
DPS Signal
Red/Blue LEDs
For a video of this installation, visit www.GenieCompany.com/AladdinConnect/InstallationVideo
NOTE: Customers using control apps from other vendors and NOT
using the Aladdin Connect® app to control this system will need to
visit www.GenieCompany.com/AladdinConnect for specic Wi-Fi
instructions.
FIG.A FIG.B
DCM
Installation Prompt
Scan for
iOS app
39386503966, 04/2018
Apple and the Apple logo are trademarks
of Apple Inc., registered in the U.S. and
other countries. App Store is a service mark
of Apple Inc.
Need help or have questions? Contact Aladdin Connect® Customer Service at 1-866-599-4995
Typical Installation shown.
Installations may vary
Scan for the
Aladdin Connect®
installation video
Scan here for additional
Aladdin Connect®
information
Scan for
Android app
39386503966_AladdinConnectEng.indd 1 5/9/2018 3:39:30 PM