Replacement Part List

1) Center idler pulley into EXTENDED header rail slot. Insert clevis pin through header rail hole

and idler pulley. Secure with cotter pin. Fig. 1.

2) Insert 5/16”-18 x 2” bolt into EXTENDED header rail and secure with nut.

3) Proceed with the assembly of the rail per Assembly Poster until step 1g.

4) Prior to step 1g, install chain extension.

5) Remove master link from threaded shaft assembly (Gold End) with needle nose pliers. Fig. 2.

6) Install chain extension with included master link. Fig 3.

7) Reinstall threaded shaft assembly to extended chain with master link removed in step 5. Fig. 3.

8) Continue with the installation poster at step 1g. Fig.4.

9) Discard original RED emergency release cord and install extended RED emergency release

cord included with this kit at step 6 on assembly poster.

Preparation: Refer to Assembly/Installation Poster, replace the header section of rail with the extension rail included with this kit.

Add Chain Extension prior to Step 1G. Add extended RED emergency release cord.

39028502639

RAIL EXTENSION KIT INSTRUCTIONS (Tube Type Chain Rail)

A Supplement To The Chain/Belt Drive Assembly & Instructions Poster

Installation Procedure

Fig. 1

Fig. 2

GOLD THREADED

HEADER END ONLY

SILVER THREADED

MOTOR END ONLY

Fig. 3

Fig. 4

Chain Extension

Master Link

ELO-02/2015

Discard original rail section

Extended rail section step 1a & 1b from assembly poster

Continue at step 1g from assembly poster

Threaded Shaft Assembly (Gold End)

PAGE 1
RAIL EXTENSION KIT INSTRUCTIONS (Tube Type Chain Rail) A Supplement To The Chain/Belt Drive Assembly & Instructions Poster Preparation: Refer to Assembly/Installation Poster, replace the header section of rail with the extension rail included with this kit. Add Chain Extension prior to Step 1G. Add extended RED emergency release cord. Installation Procedure 1) 2) 3) 4) 5) 6) 7) 8) 9) Center idler pulley into EXTENDED header rail slot. Insert clevis pin through header rail hole and idler pulley.
PAGE 2
INSTRUCCIONES DEL KIT DE EXTENSION DEL RIEL (Riel de Cadena Tipo Tubo) Un suplemento al ensamblaje y póster de instrucciones del accionamiento de cadena / correa. Preparación: Consulte el póster de ensamblaje / instalación, reemplace la sección del riel del cabezal con el riel de extensión incluido con este kit. Añada la extensión de la cadena antes del Paso 1G. Añada el cordón ROJO extendido de liberación de emergencia.