Owner's Manual

OPEN

STOP

CAL

RUN

SCROLL

SET

CLEAR

OPEN

STOP

CAL

RUN

SCROLL

SET

CLEAR

Section 8: Troubleshooting

These operators display their status on the integrated display. Each time the operator

runs, stops, reverses or refuses to run, the display will indicate why the action did, or did

not, take place.

Once an error code has been generated, the operator will continue to display the

error code while the operator is not running. This error code can be cleared by pressing

the STOP button or STOP key on the keypad. The error code will automatically clear

when the operator stops at the down limit. Error codes will continue to be stored in the

operator’s Error Code Memory after they have been cleared from the display in the

Run Mode.

Display Operation in Run Mode

To aid in troubleshooting problems, these operators include an error code memory that

stores the last 10 error events. These codes are stored with or without power. The last

error code detected is also displayed on the LCD until the stop button or key is pressed

or the operator stops at the down limit.

The error code memory stores the last 10 error codes in sequence. Once 10 codes are

stored, the oldest code

is erased to make room for the newest code. These codes are

displayed in calibration mode. The display will flash the number of the error code and

the 2-digit error code followed by a description of the error code. Fig. 1 & 2.

Error Codes

ERROR CODE 1 41

Figure 1

REV ONE BUTTON

Figure 2

3.18.1

www.geniecompany.com 08-12

Counter Door Operator

GCL-GCX