User Guide

ManualsBrandsGenie ManualsBuilding SuppliesGenie Wireless Keyless Keypad, with Intellicode Security Technology, for Genie Garage Door Openers, GK-R

Programming

Quick Reference Card

For help, refer to the owner ’s manual or call 1-800-35-GENIE.

WARNING: The door could move during programming. S tay clear of door

and all moving parts at this time.

Programming Wireless Keyless Entry Pad

Model Number GK-BX, P/N 37224R

Locate your Opener’s

Programming Buttons and LED:

The process of programming ONE

keypad to ONE opener is complete.

NOTE: If your LED light is green, please begin

at the last step on the back of this card. If the

LED light is red, continue below.

Setting the PIN

for the First Time:

1. Press in order the numbers

3-5-7

2. Press the Program key

3. Type your new PIN (3-8 digits)

4. Press the Program key again

You are now ready to program

the keypad to an opener. For use

on a Single Door, continue right

to 1A OR 1B.

1A. If they look like this:

• Press Program Set button 2

seconds until the round LED turns

blue, then release. The long purple

LED will blink. Immediately

proceed to Step 2 below.

-OR-

PROGRAM

SET

PROGRAM

SET

PROGRAM

SET

Synchronizing Keypad to Opener

1B. If they look like this:

• Press the Learn Code button and

LED will blink. Immediately

proceed to Step 2 below.

2. Type your new PIN on the

keypad.

3. Press Up/Down key and Opener

LEDs will stay on steady.

4. Press Up/Down key again and

Opener LEDs turn off.

5. Press Up/Down key a third time

and Opener runs.

RADIO

SIGNAL

LEARN

CODE

LEARN

SET

OPEN

FORCE

CLOSECODE

LEARN LIMITMANUAL

RADIO

SIGNAL

LEARN

CODE

RADIO

SIGNAL

LEARN

CODE

Synchronizing Keypad to Opener

To use the keypad to control

multiple doors, continue

directly to the Multiple Door

Section on the back.

Keypad Overview:

Keypad

(enter)

LED

Keypad

(enter)

LED

Keypad

(enter)

LED

Summary of content (2 pages)

PAGE 1
Programming Quick Reference Card Programming Wireless Keyless Entry Pad Model Number GK-BX, P/N 37224R LED For help, refer to the owner’s manual or call 1-800-35-GENIE. Keypad WARNING: The door could move during programming. Stay clear of door and all moving par ts at this time. (enter) Keypad Overview: Locate your Opener’s Programming Buttons and LED: 1A.
PAGE 2
Multiple Door Section: Changing an Existing PIN: 1. Type your new PIN (3-8 digits). 1. Enter your current PIN. 2. Press the Program key 2 times. 2. Press the Program key 1 time. 3. Enter how many total doors you want to control with this keypad (press 2 or 3 accordingly). 3. Type your new PIN (3-8 digits). 4. Press the Program key 1 time. 4. Press the Program key. NOTE: Unlike “Resetting PIN,” you DO NOT need to reprogram your opener after changing your PIN.