Genomics CNC Y-Axis Extension Kit for 3018 Series CNC Router Assembly Guide gg Par F A
RY Disassembly s Disconnect & Remove All Wires Connecting to the Base of Your CNC Before you stark: Taking your CNC apart in ea mast, it is best to start by disconnecting all wires related to the ¥ axis, including wiring for limit switches {if using a Pr Over CNC} and even going as far as io cut any zip-ties securing the wires. Replacements for the latter were included with your expansion kit for replacing these.
Ri Gather All of Your Components Before moving forward with the final assembly, i is best to take a moment and organize all of the pairs you have accumulated, as shown in the image below: ® Parts List 1x Assembled Front Panel 6x M5*18 Bolts for Front Pane! 1x Assembled Back Pans! 8x M516 Bolts for Back Panel x Assembled CNC Bed 1x Spring for CNG Bed 1x Copper Nut for CNC Bed © Parts to be Discarded Zx Original Side Extrusions 2x Original Linear Calls 4x Original Y-Axis Lead Screw 2x Acrylic Side Panels 8x M
RY ad CNC Base Assembly Attach the Extended Side Extrusions Linear Calls to the Back Panel. Install Extended Lead Screw into CNC Bed Through Spring & Copper Mut. The CNC bad is assembled as follows, with the paring and copper nut: i aN an Spring Copper mut For assembly, you will need to hold the copper nut and spring in a compressed condition in the notched opening of the Nut Seat while continuing to screw in the Lead Screw through the rear of the nut seat until the copper nut is engaged on the threads.
RY ad CNC Base Assembly Install the Bed with Threaded Lead Screw info the Liner Calls Already Attached io Back Panel. Secure the Lead Screw to the Y-Axis Stepper Motor through the Couplet. Sat screw Coupling IN Lead screw BE OH Don't forget to tighten the set screws on tha couple in order to lock things down. install the Front Pans! & Square Frame The front pane! installation is says enough, but squaring the frame requires some additional explanation.
STEP 4 Final Assembly The process of mating the base frame with the gantry assembly mirrors the mass process as when you assembled your ONG for the first time, the only major difference is that rather than having the gantry spaced 48 5mm from the rear of the frame, you are now going to want it to move more forward in order fo take advantages of the expanded Y-Axis. Rather than give you a specific number, it is strongly suggested that you move the gantry as far forward as your wiring will allow.
Genomics If you dean any assistance, please contact us via: EE | £] Facebook messenger: hitps:fim mainstream Help and support is also available from our Facebook Group
