Installation Manual

Before inserting a new collet make sure;
The inside of the tool holder is clean and free from dust and debris.
The collet itself is clean, on the outside of the tapers, in the spaces between the collet segments
and in the bore which will take the bit.
The nut is clean and free from debris around the retaining ring and on the bottom taper.
Do not insert a collet into the nut with a bit inserted into the collet! This will limit the amount
the segments of the collet can move and will make it nearly impossible to seat the collet into the
nut correctly.
Locate the widest point of the retaining ring in the nut and engage the slot of the collet into it,
while pushing it into the nut (1) press it straight (2), it will ʻ clip ’ in. After insertion check that the
collet is straight and is fully seated into the nut.
•
•
•
•