Installation Manual

If excessive vibration occurs when the spindle is turning a process of elimination can identify the
cause. Remove the nut, collet and bit from the holder and try again. If the vibration persists
check that the holder is straight and secure on the motor shaft, if it still persists then the motor
itself is the suspect.
Remove the bit from the collet and reattach the nut and collet into the holder and try again. If
the vibration persists check the collet mounting into the nut. If it goes away check that the collet
is the correct size for the bit shank or try a di ff erent bit.
NOTE: These checks should be made without performing any cutting. If excessive vibration
occurs when cutting it is often due to over stressing the router with the depth of cut and/or feed
rate being too high.