REQUIRED FOR ALL EXTERIOR INSTALLATIONS • Hand Saw • Level • Utility Knife • Drill • Tape Measure • Screw Driver Bits • Caulking Gun for a 10 oz Tube • Framing Square • 1.625” Non-Corrosive Deck Screws • Marker • 2.
PREPARATION Tips for Success GenStone Products are designed to be applied to any flat structural substrate that is clean and free of debris. The positive shiplap edge (red below) always goes on the bottom. Stagger the connections throughout the wall to avoid visible seams.
ATTACHING PANELS AND CORNERS For exterior projects, start with an “S” pattern of construction adhesive on the back of each Product. Adhesive is not recommended for interior projects with a drywall substrate. Ensure the Product is level before fastening as outlined by Product below. Next, feel throughout the face of the panel for any flex, if you notice any flex between the panel and the substrate, eliminate the flex with a screw in the face of the Product.
ATTACHING TRIM For exterior projects, start with an “S” pattern of construction adhesive on the back of each trim piece. Adhesive is not recommended for interior projects with a drywall substrate. Before attaching the trim, run a bead of Big Stretch caulk along the side of the trim piece where it will come into contact with other GenStone Products or obtrusions such as electrical boxes. Ensure the Product is level before fastening the trim with screws in the face of the trim as outlined below.