Installation Guide
GenStone products are designed to provide a realisc
look of brick. Although installaon of GenStone is
much easier than tradional masonry applicaons,
proper installaon requires good planning and
preparaon. Each applicaon varies, therefore
we recommend you read this enre guide before
beginning your project. When calculang the amount
of GenStone needed for your project, remember that
you will need addional pieces for unique cuts, such
RECOMMENDED TOOLS
OPTIONAL TOOLS
• Hand Saw
• Ulity Knife
• Tape Measure
• Caulking Gun for a 10 oz Tube
• 1.625” Non-Corrosive Deck Screws
• 2.5” Non Corrosive Deck Screw (for Ledger)
• Screw Driver Bits
• Drill
• Framing Square
• Level
• Sandpaper
as gables, end walls, or areas around windows. A
minimum of a 5% addional product is recommended
for mely compleon of your job. Keep in mind,
your le over product can be used in otherareas
of your project to. It is also recommended that
addional panels be purchased and scrap pieces be
kept in case a repair is needed. Observe and Obey
All Safety Rules and Recommendaons set forth by
Tool Manufacturers and Local, State, and Federal
Authories for Any Building Codes Applicable.
BRICK PRODUCT TO WOOD
Exterior Installaons Interior Installaons
• Marker
• Gloves
• Safety Goggles/Glasses
• Table Saw
• Compound Miter Saw
• Jig Saw
• Power Sander
• Rubber Mallet